I'm new , please help!

magicJack Tips and Tricks

Moderators: Bill Smith, Pilot

Post Reply
atti_mac
MagicJack Newbie
Posts: 4
Joined: Sat Sep 26, 2009 2:50 pm

I'm new , please help!

Post by atti_mac »

I'm sorry if this topic already opened somewhere, I couldn't find it.
Can somebody help me how to dump the memory from MJ, and send to my router or voip phone? I would like to help to my mom. She don't know to much computers, and if my sister isn't home , she is not able to call me with MJ. I read somewhere it is an option to run MJ without pc. Plug the phone to the router, or just use a voip phone.
Also can you tell me what phones , or routers can do this?
Please , if you have time give me a step by step process for this, because I can't do it for her , my sister will do this process. I'm living in a different country far away from them. It will be a huge help for us. Thank YOU!
Sorry again , if is already listed, like I said I couldn't find it.
Regards, Atti
Cablespider
magicJack Apprentice
Posts: 28
Joined: Wed May 27, 2009 4:12 pm

Post by Cablespider »

Everything you need to know, for the most part, is in these forums. I suggest you or your sister start reading and at least attempt one of the procedures. How you go about it will depend on your hardware. Then, if you get stumped, you can be a bit more specific when asking questions.

No one is going to be able to help at all unless you are more specific. Determining what hardware you have available is a first step. You can then use the various threads to see if a setup procedure has been outlined. If you have no hardware at all, that's no problem. Scour the threads to see what other people are using and have had success with. You can then decide what to purchase based on your needs.

There is a wealth of information in these forums. And I mean a lot! Chances are, you'll find what you are looking for. Much has been covered. Read, read, read. Personally, I think it would be much easier to show your mom how to use the softphone and call it a day. A lot of what's covered here is not for the faint at heart.
atti_mac
MagicJack Newbie
Posts: 4
Joined: Sat Sep 26, 2009 2:50 pm

You were right!

Post by atti_mac »

I spent few hours yesterday, so I understood, what is going out with MJ.
I got it out the password, learned about SIP, and I was able to run MJ on my IPHONE with WIFI. This site is amazing!
I just needed to spent more time.
Thank You!
MST
magicJack Apprentice
Posts: 28
Joined: Mon Nov 02, 2009 11:35 pm

Post by MST »

Hmmm I get my sip info however I cannot get working with SIP trunk Trixbox. I have fallowed the same configuration from prevous MJ that works perfectly....

Any advice?

THX
MST
Post Reply