ANYONE USED MJ WITH I-PHONE
Moderators: Pilot, Bill Smith
ANYONE USED MJ WITH I-PHONE
I was wondering anyone used MJ with I-Phone.Is it possible?
-
- Dan Should Pay Me
- Posts: 613
- Joined: Tue Jan 01, 2008 9:11 pm
- Location: LikeMagic Pacific NW
iPhone does not have any USB port so it's not possible to use MJ device with iPhone.
However, it's possible to use MJ account's SIP credentials on the iPhone for free VOIP calls (via WiFi internet connection,) but not with the iPhone's original firmware. You'll have to jailbreak it first, load Fring to support SIP calling. See these URLs for more info:
http://www.engadget.com/2008/04/15/ipho ... -to-fring/
http://www.zatznotfunny.com/2008-04/fri ... ip-client/
http://www.fring.com/
However, it's possible to use MJ account's SIP credentials on the iPhone for free VOIP calls (via WiFi internet connection,) but not with the iPhone's original firmware. You'll have to jailbreak it first, load Fring to support SIP calling. See these URLs for more info:
http://www.engadget.com/2008/04/15/ipho ... -to-fring/
http://www.zatznotfunny.com/2008-04/fri ... ip-client/
http://www.fring.com/
Re: ANYONE USED MJ WITH I-PHONE
Yes, I'm using MJ on a SunRocket 6011S. Setup was easy thanks to xxM5xx help. Cost was ~$18 shipped via Amazon. 6011S has a built-in router, one WAN and one LAN port. If your looking for a low-cost, low-power consumption solution and you have SIP credentials, this may fill the bill for you.banaa007 wrote:I was wondering anyone used MJ with I-Phone.Is it possible?
Siphon Settingsinterrupt wrote:Yeah, works like a charm with fring. Just make sure you put ":5070" at the end of the proxy url. I tried using siphon but i didnt have any luck. Probably had something to do with the way i was entering information cause it just works awesome in fring.
Username: Exxxxxxxxxx01
Password: xxxxxxPasswordxxxxxx
Server: talk4free.com
Siphon over EDGE/3G: on
Advanced Settings
Reg Timeout: 3600
Proxy Server: proxy1.yourcity.talk4free.com:5070
Enabled NAT: off
Auth. Username: Exxxxxxxxxx01
Contact: not sure what this is for
Transport Options (under advanced settings)
Local Port: 5070
RTP Port: 120000
STUN Domain: ???
STUN SERVER: ???
Debugging log file: disabled
ISP: AT&T DSL 768kb up / 6mb down
Router: D-Link DGL-4500 (ALG SIP=off)
ADSL Modem: Moto/Netopia 2210-02 (bridged)
Implementation:
- Revised magicJack on a HP T5710 512/512 thin client
- magicJack SIP on iPhone using Siphon & Backgrounder
Router: D-Link DGL-4500 (ALG SIP=off)
ADSL Modem: Moto/Netopia 2210-02 (bridged)
Implementation:
- Revised magicJack on a HP T5710 512/512 thin client
- magicJack SIP on iPhone using Siphon & Backgrounder