Trixbox CE and MagicJack outgoing calls fail

[cogentnexus]

Hi I followed a tutorial on digital offensive to get magicjack to work with trixbox. I got xlite to work using magicjack sip credentials for both incoming and outgoing calls. I also got my trixbox ce 2.6.2 to work but only for incoming calls. When I try to make outgoing calls I receive a prompt saying all circuits are busy now.

Is there a systematic way to go about troubleshooting this. I know the route information is ok cause I can put the same route and use my zap/1 channel and the calls go through.

The Xlite softphone is on a windows PC and on the same LAN. I have compile MJMD5 on the trixbox and the xlite softphone actually uses the proxy on the trixbox and works fine.

I have read in some forums it could be the codec, while others say it could be the callerid info not being sent? Also Why exactly would I need to patch the kernel? Any advice or direction would be most helpful. I feel I'm so close.

[genxweb]

Do you have a outbound route configure and what trunk is it set to use? Can you post some logs from the asterisk/full

Feel free to contact me offline. Sorry I did not respond on my blog. I been out of town with my family.

[Coward]

have you found a solution for your outgoing, i do have the same problem
xlite work but not trixbox

thanks in advance