Unable to get SIP information using Stroth's software

[macman4hire]

When I tried to use "Get Current SIP Information", I recieved the following error message Invalid Path3 in Config.ini. Correct and try again. I just purchased an PAP2 and want to obtain all the info I will need to configure it.

Thanks,
Todd

[oldtimercurt]

macman, you need to review Stroth's instructions for setting up the variables in his utilities to properly modify the ini file. By the way, once you no longer get the error, be prepared to not have instant success. The info doesn't hang around long after MJ starts so you might miss it. I've found that if you're ready to grab the SIP info, restart MJ. When the progress bar is about 75% across, start the SIP grabber. I've had quite regular success with that technique.

OTC

[VisioX]

I had the same issue.
I just changed the delay time to 5 seconds and it worked fine for me on my laptop.

[psychdoc]

Ack, no matter what I do, I can't seem to make it work. Is the program looking for the mjusb folder? (Mine is the mjusbsp folder... would that make a difference?) Is there another way to grab the SIP login and password without using stroths?

[psychdoc]

Ok, I found an older program (also written by stroths I believe) at magicjackhacks.com that allowed me to get my MJ password. Click the "sip password finder" at this link:

http://magicjackhacks.com/index.php/dow ... ainmenu-50

And I'm up! I'll post this to the other thread on this board where a related discussion was occurring.