Hi,
Will the MJ work on a WYSE 9455XL running XPe?
If so, is there a guide for what I need to configure on this model?
Thanks
MJ on WYSE 9455XL
Moderators: Bill Smith, Pilot
-
nighthawks
- MagicJack Expert
- Posts: 87
- Joined: Sat Feb 27, 2010 1:14 pm
WYSE
I got one and it was an 1gig w/512 ram and an 6gig micro drive, the unit was MJ ready. I have an neoware 400mhz w/265 ram, I wanted something with more power. Not the case with the WYSE, I had more trouble with it running MJ than my neoware, why I don't know.
Long story short, I went back to the neoware, updated my linksys router with DD-WRT firmware, bought a Hawkings broadband booster and it all works the 400 mhz 256k TC is like the "little train that could".
Sometime I'm going to go with a HP T5700 series at least 1gig and 512 to 1gig ram and a micro drive.
WYSE hummmmm.......it just didn't work for me..
Long story short, I went back to the neoware, updated my linksys router with DD-WRT firmware, bought a Hawkings broadband booster and it all works the 400 mhz 256k TC is like the "little train that could".
Sometime I'm going to go with a HP T5700 series at least 1gig and 512 to 1gig ram and a micro drive.
WYSE hummmmm.......it just didn't work for me..
-
Bill Smith
- Dan isn't smart enough to hire me
- Posts: 221
- Joined: Sun Aug 23, 2009 9:57 am
My experience with a WYSE 9455 has been very good; no issues at all. It was purchased from someone who used to sell them from this site and eBay.
It is configured as follows: 4gb microdrive, 512mb memory, fresh XPe SP2 install with all MJ non-essential software and services excluded (e.g. RDP, VNC, and management software), scheduled restart nightly, reboots automatically if there is a power outage. No keyboard, mouse, or monitor is connected since the TC is used solely for MJ. No anti-virus is installed either. The thin client is directly connected to the router.
The MJ works great for me with this setup and has for over 1.5 years. Unlike some other posters, I've not had any issues with the Linksys router. I have changed the firmware with the Linksys provided update.
It is configured as follows: 4gb microdrive, 512mb memory, fresh XPe SP2 install with all MJ non-essential software and services excluded (e.g. RDP, VNC, and management software), scheduled restart nightly, reboots automatically if there is a power outage. No keyboard, mouse, or monitor is connected since the TC is used solely for MJ. No anti-virus is installed either. The thin client is directly connected to the router.
The MJ works great for me with this setup and has for over 1.5 years. Unlike some other posters, I've not had any issues with the Linksys router. I have changed the firmware with the Linksys provided update.