PAP2 Ver2 Unlock help

oxigenado · Post by **oxigenado** » Tue May 20, 2008 9:21 pm

I've succesfully got my sip creds (Thank you), I've been trying to unlock my pap2 v2, previously used for vonage, I used cyt 4.6 unsuccessfully, I still need to try the ftp transfer but not sure if the file is compatible with the ver2, apparently the version I founf is for the pap2 only, anyone tried this? or have a better way?

I also tried to configured my (sprint) wm6 ph using schap's setup voip ver 0.3, I can hear the ph ringing but I can dial any help will be appreciated on this matter.

Thank you in advace.

somenon3 · Post by **somenon3** » Wed May 21, 2008 4:29 pm

have you checked these instructions?:
http://www.bargainshare.com/index.php?showtopic=87504

I just got my RT31P2 unlocked, and spent quite a bit of time getting the vonage stuff OUT and figuring out the MJ config. Once you get yours unlocked, if you run into troubles, PM me and I can give you a hand, or at least try to give you a hand.

-Some

onlinepcfun · Post by **onlinepcfun** » Wed May 21, 2008 5:23 pm

Here's the pointer...
Check out this one... http://www.dslreports.com/forum/remark,16514227 - read this thouroghly. That has all the information needed...
-downgrade to 1.00.13
-run CYT to unlock (but I guess this can get locked again so continue with next steps) - you can't use MJ at this point as that firmware will not allow alpha userID
-upgrade to 1.00.16
-create patch firmware from RTP300 firmware for ur PAP2v2 as per GrauerFuchs's instructions in that forum (about 25+ pages) - you need access to a linux box to create firmware urself.
-apply that firmware to your box
-That will give your box RTP300 look and totally unlocked!